The Polishin’ Pal is a detailer’s best friend! The ergonomic, urethane handle makes product application a breeze with changeable foam pads. Now the Polishin’ Pal makes detailing clay easier and more efficient to use with the Clay Disc for the Polishin’ Pal!
The Clay Disc enables you to clay your vehicle using the Polishin’ Pal. The disc has hook & loop on one side and a smooth, slightly tacky surface on the other side. Stick the hook & loop side to the bottom of your Polishin’ Pal and spread the clay over the sticky side. The Clay Disc holds the clay as you rub to keep your hands clean and allow you to use the clay more efficiently.
What do we mean by more efficiently?
The average clay bar is 2 oz. and shaped in a 3” x 1.5” brick. A lot of people hold the brick by the edges or press in the middle. Using this technique, you’re only using 4.5 square inches of the clay at a time. At this rate, claying your vehicle takes all day!
The Clay Disc is 3.5” in diameter. That’s 9” of surface area. Spread the same 2 oz. clay bar over the disc and you’re using roughly twice times the surface area of clay at a time. The disc allows you to cover more area and complete the task faster than the old fashioned method. Plus, the Polishin’ Pal is easier to grasp than a small piece of clay. You’re less likely to drop the clay and your hands say clean!
To use:
Stick the clay disc to the Polishin’ Pal handle using the hook & loop side of the disc. Flatten approximately 2 oz. of clay into a round patty and press it on the disc. Spray a 2 square foot area of your vehicle with clay lubricant. Holding onto the handle, glide the clay back and forth across the wet area. You may feel the clay grab at first. Keep rubbing until it glides smoothly. At this point, the paint is clean. Wipe off any clay residue and continue to the next section. Check the clay often; if it is soiled, reshape it to reveal a clean portion.
The Clay Disc is the neat and efficient way to clay!
To use:
