  Shield your glass with tough polymer protection.
Automotive glass protection should be as commonplace as paint protection. Diamondite Glass Poli-Shield is tough protection against everyday assailants, including industrial fallout, tree sap mist, bugs, hard water, and rail dust. This polymer sealant bonds to the glass, filling in its microscopic grooves, to completely block out environmental pollution and moisture.
Diamondite Glass Poli-Shield is a thick polymer sealant designed specifically for glass. Because Poli-Shield is water-based, the sealant forms a crystal clear barrier against the elements. It fills in tiny chips and nicks to minimize their appearance and seal them off from contamination. Glass looks visibly clearer and cleaner under a coat of Glass Poli-Shield.
Glass stays cleaner with a slick polymer coating. Diamondite Glass Poli-Shield reduces surface tension to repel water and oil, and to resist the bonding of most contaminants. Treated glass resists water spots, mineral etching, oily films, and it provides some resistance against scratching.
Poli-Shield maintains the glass’ clarity and locks in the results you have achieved with Diamondite Glass Resurfacing Creme. After polishing the glass, it may lose its “slip”, the quality that causes water to roll off. Diamondite Glass Poli-Shield restores the slip and then some with its moisture-repellant polymer coating.
You will notice the consistency of Diamondite Glass Poli-Shield is like a gel. The gel is better able to fill in minor chips to minimize their appearance. The clear gel dries transparent and streak-free on the glass. And, because this thick formula is designed for automotive glass, it provides unparalleled protection against the elements.
Protect the glass on all of your vehicles with Diamondite Glass Poli-Shield.
Directions:
- Apply an X of Diamondite Glass Poli-Shield across the gel applicator pad included with the Diamondite Glass Repair Kit and turn the polisher on between 800-1000 RPM. Work in an overlapping motion until a 2 x 2 sq. ft. area has been covered. You are just applying product so there is no need to apply pressure. Wipe the surface clean using a microfiber towel.
- By hand, use a clean, soft foam applicator to spread a thin coat of Glass Poli-Shield over the glass. Wipe clean with a microfiber towel.
4 oz.
|
|
