| || |
|Blackfire Wet Diamond, All Finish Paint Protection|
Don't just turn heads.... CREATE WHIPLASH!
BLACKFIRE Wet Diamond All Finish Paint Protection is state-of-the-art paint protection! This sophisticated oil-in-water emulsion is safe for all finishes, with or without a clear coat. Wet Diamond All Finish Paint Protection uses a revolutionary, crystal polymer developed by Wacher-Chemie, Munich, Germany. This polymer refracts light like a diamond to create a head-turning finish.
This emulsion contains a small amount of a very refined mineral spirit in a water base. Multiple coats can be layered to deepen the gloss without drying or weakening the paint.
BLACKFIRE Wet Diamond All Finish Paint Protection is boosted with Polycharger for maximum shine, slickness, and longevity. Polycharger promotes polymer cross-linking to enhance their effectiveness.
BLACKFIRE Wet Diamond All Finish Paint Protection can be used by itself as the final sealant or as the foundation of BLACKFIRE's signature Wet Ice Over Fire shine.
BLACKFIRE Wet Diamond All Finish Paint Protection can be applied by hand or dual action polisher. It applies easily and buffs off uniformly even in climates of high heat and high humidity.
Wet Diamond’s incredible shine is resistant to detergent washings and ultraviolet radiation. This keeps your car’s finish protected month after month and wash after wash.
Creates a deep gloss that “shimmers” like water.
Colors radiate with depth and clarity.
Highly resistant to UV and infrared radiation.
Safe for all painted finishes.
Wet Diamond All Finish Paint Protection is a pure sealant without any cleaning power. For best results, older vehicles should be pre-cleaned with BLACKFIRE Gloss Enhancing Polish or Scratch Resistant Clear Finishing Polish before first time application.
Hand Application: Always use on a cool surface out of direct sunlight. Apply a quarter size amount of product on a dry applicator pad and wipe on the surface using small, circular motions. Allow Wet Diamond All Finish Paint Protection to dry before buffing. Buff haze with a clean Cobra microfiber towel.
Machine Application: Apply BLACKFIRE Wet Diamond All Finish Paint Protection using a finishing pad or wax pad on a dual action polisher, such as the Porter Cable 7424XP. Work on a small area, about 2 sq. ft., out of direct sunlight. Apply two 6 to 8 inch lines of All Finish Paint Protection directly onto the surface. With the machine off, spread the sealant over the surface using the dry foam pad. This coats the foam pad and the paint with sealant. Place the pad on the paint and turn the machine on. Set the speed dial on the polisher between 3 and 4. Work the pad over the surface in a back-and-forth motion and then an up-and-down motion. Apply until the sealant starts to dry. Cover one section of the vehicle at a time (i.e. the hood, a door, fender, etc.) Allow a haze to form. Hand buff to a brilliant shine with a Cobra Microfiber Towel.
For ultimate depth and wetness, apply one coat of BLACKFIRE Wet Diamond All Finish Paint Protection and allow to cure for eight hours. Top with two coats of BLACKFIRE Midnight Sun Ivory Carnauba Paste Wax. The resulting shine is wetness over energy, a Wet Ice over Fire Shine!
Wet Diamond All Finish Paint Protection is VOC compliant in all 50 states.
|64oz. Blackfire Wet Diamond, All Finish Paint Protection ||128 oz. Blackfire Wet Diamond, All Finish Paint Protection|
Call Toll-Free 1-800-215-4460 to speak to a Customer Service Representative or email us